The PV/MW heavy duty sump pump is designed for applications requiring greater reliability and durability. The bearing assembly allows the pump to operate in the “snore” condition without damage to the bearings. It is designed for handling abrasive slurries and corrosive fluids by using either elastomer or alloy lined wet ends components. The pump is suitable for mining, chemical treatment, waste water treatment, gravel and general process application.

Wide range of hard metal or rubber wet parts to ensure longer service life Double suction semi-open impeller, effectively reduce the axial load No submerged bearing avoids the need for gland or bearing flushing water Suction pipe or agitator available, which can be used for pumping the high density slurries under the pit MVR models feature full rubber covering for corrosion resistance Can be run in insufficient suction duties The screened inlets and large impeller passages reduce the risk of blockages

Specification

Type : PV/MW
Standard : -
Discharge Flange : DN 40 - DN 250
Capacity : 1000 m³/h
Head : 40 m
Temperature of Pumped Liquid : +95 °C
Maximum Operating Pressure : 16 Bar (24 Bar)*
Frequency : Single/Three-phase 50 Hz - 60 Hz
Pump Speed : 300 ~ 3000 RPM
Viscosity : 0~2000 cps
Fluid : High Density Slurry
Impeller Type : Open
Casing : Ductile Iron
Wear Parts : Chromium Steel / Rubber
Impeller : Chromium Steel / Rubber
Shaft : SS420 / SS329
Seal : Mechanical Seal
Suction / Discharge Flange : -